R22 refrigerant will be replaced by new environmental protection refrigerant

At present, all countries in the world in phasing out traditional refrigerants such as R22, advocate using environmental protection refrigerants. Competing has carried out the study of R22 refrigerant alternative technologies. After several years of experiment and evaluation, R22 refrigerant alternatives more mature has the following several kinds: a refrigerant R22, R407c, refrigerant, is among the candidate calls for higher R22 substitutes in the alternative refrigerants. This is because the R407c thermodynamic properties and R22 is similar, their work pressure and refrigerating capacity are close to. Which alternative is simple, the original R22 machine after using refrigerant R407c except oil change, adjust the volume of injection system impact and throttling element, the compressor and the rest of the equipment are not change. But the refrigerating capacity of the machine after using R407c and eer than a slight decline when using R22, and the biggest refrigerant R407c defects may be large temperature glide. 2, 134 - a refrigerant, the non azeotropic mixture in 30/70% has the best thermodynamic performance. Many report points out that the volume of injection system to rush, to optimize the heat exchanger after the air conditioning refrigerating capacity after the equipment adopts the mixed working medium completely with R22, and also what effect can raise a few percentage points. Its disadvantage is that under certain conditions the flammability, though it is under normal working conditions is not flammable. Three, R410a refrigerant: its thermal performance is very close to the single working medium, although it is similar to the thermal properties of R22 are not very, but chances are R22 most promising HFC substitute. Using R410a refrigeration system retrofit thoroughly, but after retrofit machines become more compact. Another advantage is its high thermal conductivity of liquid phase, low viscosity, make its have is better than that of the transmission properties of R22. R410a refrigerant in the proper pressure range of Canon of optimization has higher than that of R22, what under the cost of the same overall efficiency can be improved about 5%, enough to make up for the retrofit design of the required fees. Four, R134a has a refrigerant: compared with R22, pressure, will reduce the cooling capacity, most of the pipeline, including heat exchanger should be expanded to reduce the pressure loss, compressor capacity will increase. The refrigerating capacity of the system after using it instead of R22 has reduced greatly, can effect comparing also fell slightly. System retrofit cost is higher, so for small residential or commercial air conditioning is unlikely to use it, but for the big water chiller especially when using a screw or centrifugal compressor is more appropriate. Overall, the research and development of alternative refrigerants are not just as simple and trial-produce, also need to invest a lot of manpower material resources, experience a long period to complete, so consumers will also be used as refrigerant R22 a period of time, will eventually be eliminated by the new environmental protection refrigerant.
Hangzhou E cool refrigeration Co.,Ltd thinks that customer satisfaction is one of the most important determinants of brand loyalty. High-quality service can be the difference between a one-time buyer and a lifelong repeat customer.
Arkool Refrigeration has a whole range of different items to help you make an informed choice every time you make a purchase. Check it!
Digging into our roots and acknowledging out heritage can be fruitful on both a high-quality and professional level of refrigerant gas.
give you an additional start capacitor suppliers option for your start capacitor suppliers, whether it being a start capacitor suppliers, start capacitor suppliers or start capacitor suppliers. Go and get more info at Arkool Refrigeration.
Many business owners and professionals use services like Hangzhou E cool refrigeration Co.,Ltd to stay on top of manufacturing industry, monitor products’ quality and keep an eye on competitors.